Siemens SINAMICS G150 - Setpoint Sources

Operation
6.5 Setpoint sources
Converter cabinet units
284 Operating Instructions, 07/2016, A5E03347396A
6.5
Setpoint sources
6.5.1
Analog inputs
Description
The customer terminal block TM31 features two analog inputs for specifying setpoints for
current or voltage signals.
In the factory setting, analog input 0 (terminal X521:1/2) is used as a current input in the
range 0 to 20 mA.
Precondition
The default setting for analog inputs was chosen during commissioning:
•
STARTER (p1000):
"TM31 terminals"
•
AOP30 (p1000):
"2: TM31 terminals"
Signal flow diagram
Figure 6-17 Signal flow diagram: analog input 0
Function diagram
FP 9566
TM31 – analog input 0 (AI 0)
FP 9568
TM31 – analog input 1 (AI 1)