Siemens SINAMICS G150 - Additional SMC30 Sensor Module (Option K52)

Electrical installation
4.10 Other connections
Converter cabinet units
166 Operating Instructions, 07/2016, A5E03347396A
4.10.20
Additional SMC30 Sensor Module (option K52)
Description
With option K50, an SMC30 Sensor Module is included in the cabinet unit. The additional
SMC30 Sensor Module enables reliable actual-value acquisition when using Safety
Integrated Extended Functions (requires a license: option K01).
Note
Safety Integrated Function Manual
A detailed description of the full functionality and handling of the Safety Integrated funct
ions
can be found in the accompanying Function Manual. This manual is available as additional
documentation on the customer DVD supplied with the device.
4.10.21
Customer terminal block (option G60)
Description
With option G60, a TM31 interface module (customer terminal block –A60) is already
installed in the cabinet unit. This provides the following interfaces:
● 8 digital inputs
● 4 bidirectional digital inputs/outputs
● 2 relay outputs with changeover contact
● 2 analog inputs
● 2 analog outputs
● 1 temperature sensor input (KTY84-130/PTC)
The description of the interfaces is given in the Chapter "Electrical Installation/Signal
connections"
Integration of the interfaces takes place using pre-interconnections prepared in the factory,
which can be selected during commissioning.