Siemens SINAMICS G150 - Page 188

Electrical installation
4.10 Other connections
Converter cabinet units
188 Operating Instructions, 07/2016, A5E03347396A
X150 P1/P2 PROFINET interface
Table 4- 67 X150 P1 and X150 P2 PROFINET
Pin
Signal name
Technical data
1
RXP
Receive data +
2 RXN Receive data -
3
TXP
Transmit data +
4
Reserved, do not use
5
Reserved, do not use
6
TXN
Transmit data -
7
Reserved, do not use
8
Reserved, do not use
Connector type: RJ45 socket
Cable type: PROFINET
Note
Connection cables
The PROFINET interfaces support Auto MDI(X). It is therefore possible to use both
crossover and non
-crossover cables to connect the devices.
For diagnostic purposes, the two PROFINET interfaces are each equipped with a green and
a yellow LED. These LEDs indicate the following status information:
Table 4- 68 LED states on the X150 P1/P2 PROFINET interface
LED
Color
State
Description
Link port
-
Off
Missing or faulty link
Green Continuous
light
10 or 100 Mbit link available
Activity
port
- Off No activity
Yellow Flashing
light
Data is being received or sent at port x