Commissioning
5.3 Procedure for commissioning with STARTER
Converter cabinet units
202 Operating Instructions, 07/2016, A5E03347396A
Figure 5-5 Set up interface
Under
select the interface corresponding to your device configuration from:
● Select the S7ONLINE access (STEP7), if the connection to the drive unit is established
via PROFINET or PROFIBUS.
● Select the DEVICE access, if the connection to the drive unit is established via the
Ethernet interface.
Click
and set up the interface in accordance with your device configuration.
The
,
and
pushbuttons are now active.
To Next Page
Loading...
