Commissioning
5.3 Procedure for commissioning with STARTER
Converter cabinet units
222 Operating Instructions, 07/2016, A5E03347396A
To select a different predefined encoder configuration, check the
Select standard encoder
from list
radio button and select one of the encoders from the list.
To enter special encoder configurations, click the
radio button and then the
button. The following input screen is displayed for you to enter the required
data.
Figure 5-25 Entering encoder data – User-defined encoder data
Select the
.
In conjunction with SINAMICS G150, the following encoders can be selected:
● HTL
● TTL
Enter the required encoder data.
Under the
tab, special encoder properties can be set, for example, gear ratio, fine
resolution, inversion, measuring gear position tracking.
Click
.
To Next Page
Loading...
