Siemens SINAMICS G150 - Page 302

Operation
6.6 Control via the operator panel
Converter cabinet units
302 Operating Instructions, 07/2016, A5E03347396A
Setting the date/time (for date stamping of error messages)
In this menu, you set the date and time.
You can also set whether and/or how the AOP and drive unit are to be synchronized.
Synchronization of the AOP with the drive enables error messages to be date- and time-
stamped.
Note
Display format for the time
T
he drive unit displays the time in parameter r3102 in the UTC format (days/milliseconds
since 1970
-01-01).
Under "Additional settings", settings for synchronization can be made:
Synchronization
(factory setting: None)
●
None
The times for the AOP and drive unit are not synchronized.
●
AOP -> Drive
– If you activate this option, the AOP and drive unit are synchronized immediately
whereby the current AOP time is transferred to the drive unit.
– The current AOP time is transferred to the drive unit every time the AOP is started.
– Depending on the set synchronization interval, the current AOP time is transferred to
the drive unit.
Note
Flashing "S"
If the AOP detects a difference between RAM and ROM during synchronization to the
drive unit, this is indicated by a
flashing "S" at the top right in the display or, if operator
input and/or parameter assignment has been disabled, by a flashing key symbol.
●
Drive -> AOP
– If you activate this option, the AOP and drive unit are synchronized immediately
whereby the current drive unit time is transferred to the AOP.
– The current drive unit time is transferred to the AOP every time the AOP is started.
– Depending on the set synchronization interval, the current drive unit time is transferred
to the AOP.
Note
Time-of-day master
The time in the drive must be set by a clock master (e.g. SIMATIC).