Siemens SINAMICS G150 - Page 565

Functions, monitoring, and protective functions
9.3 Extended functions
Converter cabinet units
Operating Instructions, 07/2016, A5E03347396A
565
Parameter
•
r0108.14
Extended brake control
•
r0899
CO/BO: St
atus word sequence control
Standstill (zero-speed) monitoring
•
r0060
CO: Speed setpoint before the setpoint filter
•
r0063[0...2]
CO: Speed actual value
•
p1224[0...3]
BI: Apply motor holding brake at standstill
•
p1225
CI: Standstill detection threshold val
ue
•
p1226
Standstill monitoring speed threshold
•
p1227
Standstill detection monitoring time
•
p1228
Standstill detection delay time
•
p1276
Motor holding brake standstill detection bypass
Release/apply brake
•
p0855
BI: Unconditionally release holding brake
•
p0858
BI: Unconditionally apply holding brake
•
p1216
Motor holding brake release time
•
p1217
Motor holding brake closing time
•
p1218[0...1]
BI: Release motor holding brake
•
p1219[0...3 ]
BI: Immediately apply motor holding brake
•
p1220
CI: Release motor h
olding brake, signal source, threshold
•
p1221
Release motor holding brake, threshold
•
p1277
Motor holding brake, delay, braking threshold exceeded
•
p1279
BI: Motor holding brake OR/AND logic operation
Brake monitoring functions
•
p1222
BI: Motor holding br
ake, feedback signal, brake closed
•
p1223
BI: Motor holding brake, feedback signal, brake released
Configuration, control/status words
•
p1215
Motor holding brake configuration
•
r1229
CO/BO: Motor holding brake status word
•
p1275
Motor holding brake contro
l word
•
p1278
Motor holding brake type