Siemens SINAMICS G150 - Page 67

Electrical installation
4.2 Checklist for electrical installation
Converter cabinet units
Operating Instructions, 07/2016, A5E03347396A
67
Item
Activity
Yes
Completed
Safety Integrated
34 Option K01
Safety license
for 1 axis
A license is required for each axis with safety functions in the
case of Safety Integrated Extended Functions.
With Option K01, the safety license for 1 axis is contained in and
activated on the compact flash card (see "Electrical installation /
Other connections / Safety license for 1 axis (option K01)").
35 Option K82
"Safe Torque
Off" and "Safe
Stop 1" safety
functions
The terminal block -X41 must be connected on site, the safety
functions must be activated prior to use via parameter assign-
ment, in addition an acceptance test must be performed and an
acceptance report must be drawn up (see "Electrical installation /
Other connections / Terminal Module for activating "Safe Torque
Off" and "Safe Stop 1" (option K82)").
36 Option K87
TM54F Terminal
Module
The terminal blocks of TM54F Terminal Module must be connect-
ed line-side; the Safety Integrated Extended Functions must be
activated prior to use via parameter assignment; in addition an
acceptance test must be performed and an acceptance report
must be drawn up (see "Electrical installation / Other connections
/ TM54F Terminal Module (option K87)").
37 Option K88
Safe Brake
Adapter
230 VAC
To control the brake, a connection must be established between -
X14 on the Safe Brake Adapter and the holding brake (see "Elec-
trical installation / Other connections / SBA Safe Brake Adapter
230 VAC (option K88)").
Required tools
You require the following tools for the electrical installation:
● Standard set of tools with screwdrivers, screw wrenches, socket wrenches, etc.
● Torque wrenches 1.5 Nm up to 100 Nm
● 600 mm extension for socket wrenches