Siemens SINUMERIK 802D sl - Page 102

Enhanced Level Commands
4.1 Program support functions (1)
04.07
4-102
© Siemens AG 2007 All rights reserved
SINUMERIK 802D sl/840D/840D sl/840Di/840Di sl/810D ISO Milling (PGM) -- 04.07 Edition
Example
M3 S300; Rotate spindle
G90G0Z100
G90 G99 G76 X200. Y--150. Z--100. R50. Q10. P1000 F120.;
Position, bore hole 1, then return to point R,
Stop at the bottom of the hole for 1 s .
Y--500.; Position, drill hole 2, and return to point R.
Y--700.; Position, drill hole 3, and return to point R.
X950.; Position, drill hole 4, and return to point R.
Y--500.; Position, drill hole 5, and return to point R.
G98 Y--700.; Position, drill hole 6, and return to the initial level.
G80; Cancel canned cycle
G28 G91 X0 Y0 Z0; Return to the reference position return
M5; Spindle stop