Siemens SINUMERIK 802D sl Programming Manual

Enhanced Level Commands
4.8 Program support functions (2)
04.07
4-144
© Siemens AG 2007 All rights reserved
SINUMERIK 802D sl/840D/840D sl/840Di/840Di sl/810D ISO Milling (PGM) -- 04.07 Edition
Status at power--on
Whether working area limitation is enabled or disabled at power--on is decided by
the following machine data:
$MC_EXTERN_GCODE_RESET_VALUES[3]
This MD is set to value 2 (G23) as default.
4.8.2 Chamfering and corner rounding commands
It is possible to insert chamfering and corner rounding blocks automatically bet-
ween the following items:
-- Linear interpolation and linear interpolation blocks
-- Linear interpolation and circular interpolation blocks
-- Circular interpolation and linear interpolation blocks
-- Circular interpolation and circular interpolation blocks
Format
, C...; Champfering
, R...; Corner rounding
Explanations
A chamfering or corner rounding block is inserted whenever the above specification
is added to the end of a block that specifies linear interpolation (G01) or circular
interpolation (G02 or G03). It is possible to specify blocks applying chamfering and
corner rounding consecutively.

Siemens SINUMERIK 802D sl Specifications

General

Brand	Siemens
Model	SINUMERIK 802D sl
Category	Controller
Language	English