Siemens SINUMERIK 802D sl Programming Manual

Enhanced Level Commands
4.1 Program support functions (1)
04.07
4-130
© Siemens AG 2007 All rights reserved
SINUMERIK 802D sl/840D/840D sl/840Di/840Di sl/810D ISO Milling (PGM) -- 04.07 Edition
N023 G00 X0 Y0 M5 ;
;
Reference position return,
spindle stop
N024 G49 Z250.0 T30 M6 ;
;
Tool length offset cancel, tool
change
N025 G43 Z0 H30 ; Initial level, tool length offset
N026 S10 M3 ; Spindle start
N027 G85 G99 X800.0 Y-350.0
Z-153.0 R47.0 F500
;
;
Positioning, then #11 drilling,
point R level return
N028 G91 Y-200.0 K2 ;
;
Positioning, then #12, 13 dril-
ling. point R level return
N029 G28 X0 Y0 M5 ;
;
Reference position return,
spindle stop
N030 G49 Z0 ; Tool length offset cancel
N031 M30 ; Program End
4.1.16 Multiple threads with G33
Syntax G33 X.. Z.. F.. Q.. is used to program multiple threads in ISO dialect T and
M mode, whereby:
X.. Z.. = Thread end position
F.. = Lead
Q.. = Initial angle
Threads with offset slides are programmed by entering starting points, which are
offset from one another, in set G33. The starting point offset is entered at address
“Q” as an absolute angular position. The corresponding setting data
($SD_THREAD_START_ANGLE) is changed accordingly.
Example: Q45000 means: Start offset 45.000 degrees
Range of values: 0.0000 to 359.999 degrees
The initial angle must always be programmed as an integer value. The input
resolution for angular data is 0.001 degrees.
Example:
N200 X50 Z80 G01 F.8 G95 S500 M3
N300 G33 Z40 F2 Q180000
This produces a thread with a lead of 2 mm and a starting point
offset of 180 degrees.

Siemens SINUMERIK 802D sl Specifications

General

Brand	Siemens
Model	SINUMERIK 802D sl
Category	Controller
Language	English