Siemens SINUMERIK 802D sl Programming Manual

Machine and Setting Data
D.3 Axis-specific setting data
04.07
D-236
© Siemens AG 2007 All rights reserved
SINUMERIK 802D sl/840D/840D sl/840Di/840Di sl/810D ISO Milling (PGM) -- 04.07 Edition
D.3 Axis-specific setting data
43120 DEFAULT_SCALE_FACTOR_AXIS
MD number Default axial scale factor for G51 active
Default setting: 1 Minimum input limit: --99999999 Maximum input limit: 99999999
Changes effective IMMEDIATELY Protection level: 7/7 Unit: --
Data type: DWORD Applies with effect from SW version: 5.2
Meaning: This machine data applies in combination with external programming languages. It is
effective with $MN_MM_EXTERN_LANGUAGE = 1.
If no axial scale factor I, J or K is programmed in the G51 block,
DEFAULT_SCALEFACTOR_AXIS is effective.
This MD is valid only if MD AXES_SCALE_ENABLE is set.
43240 M19_SPOS
MD number Position of spindle (degree) when commanding M19
Default setting: 0 Minimum input limit: --359.999 Maximum input limit: 359.999
Changes effective IMMEDIATELY Protection level: 7/7 Unit: --
Data type: DOUBLE Applies with effect from SW version: 5.2
Meaning: Das Settingdatum ist auch im Siemens--Mode wirksam.

Siemens SINUMERIK 802D sl Specifications

General

Brand	Siemens
Model	SINUMERIK 802D sl
Category	Controller
Language	English