Enhanced Level Commands
4.4 Eight--digit program number
04.07
4-134
© Siemens AG 2007 All rights reserved
SINUMERIK 802D sl/840D/840D sl/840Di/840Di sl/810D ISO Milling (PGM) -- 04.07 Edition
4.4 Eight--digit program number
An eight--digit program number selection is activated with $MC_EXTERN_FUNC-
TION_MASK, bit6=1. This function affects M98, G65/66 and M96.
y: Number of program runs
x: Program number
Subroutine call M98
$MC_EXTERN_FUNCTION_MASK, bit6 = 0
M98 Pyyyyxxxx or
M98 Pxxxx Lyyyy
Program number max. 4--digit
Always add 0s to extend program number to 4 digits
E.g.: M98 P20012 calls 0012.mpf 2 runs
M98 P123 L2 calls 0123.mpf 2 runs
$MC_EXTERN_FUNCTION_MASK, bit6 = 1
M98 Pxxxxxxxx Lyyyy
No zeros are added, even if the program number has less than 4 digits.
The number of runs and program number cannot be programmed in P(Pyyyyxxxxx),
the number of runs must always be programmed with L!
e.g.: M98 P123 calls 123.mpf 1 run
M98 P20012 calls 20012.mpf 1 run,
Important: No longer compatible with ISO Dialect Original
M98 P12345 L2 calls 12345.mpf 2 runs
Modal and block-by-block macro G65/G66
$MC_EXTERN_FUNCTION_MASK, bit6 = 0
G65 Pxxxx Lyyyy
Always add 0s to extend program number to 4 digits. Program number with more
than 4 digits generates an alarm.
$MC_EXTERN_FUNCTION_MASK, bit6 = 1
M65 Pxxxx Lyyyy
No zeros are added, even if the program number has less than 4 digits. Program
number with more than 8 digits generates an alarm.
To Next Page
Loading...
Need help?
General
