Siemens SINUMERIK 802D sl Programming Manual

Enhanced Level Commands
4.1 Program support functions (1)
04.07
4-127
© Siemens AG 2007 All rights reserved
SINUMERIK 802D sl/840D/840D sl/840Di/840Di sl/810D ISO Milling (PGM) -- 04.07 Edition
Unit of F command
Metric input Inch input Remarks
G94 1 mm/min 0.01 inch/min Decimal point pro-
gramming allowed
G95 0.01 mm/rev 0.0001 inch/rev Decimal point pro-
gramming allowed
Cancel
A G code of the 01 group (G00 to G03) and G74/G84 should not be specified in a
single block or else G74/G84 will be canceled.
Tool offset
Tool offsets are ignored in the canned cycle mode.
4.1.14 Canned cycle cancel (G80)
G80 cancels canned cycles.
Format
G80;
Explanations
The values of point R and point Z are cleared, all canned cycles are canceled and
normal operation is performed. In addition, the values of all addresses programmed
with drilling cycles are cleared.

Siemens SINUMERIK 802D sl Specifications

General

Brand	Siemens
Model	SINUMERIK 802D sl
Category	Controller
Language	English