Siemens SINUMERIK 802D sl Programming Manual

D-215
© Siemens AG 2007 All rights reserved
SINUMERIK 802D sl/840D/840D sl/840Di/840Di sl/810D ISO Milling (PGM) -- 04.07 Edition
Machine and Setting Data
D.1 Machine/Setting data
10604 WALIM_GEOAX_CHANGE_MODE
MD number Work area limitation when switching geometrical axes
Default setting: 0 Minimum input limit: 0 Maximum input limit: 1
Changes effective after Power On Protection level: 2/7 Unit: --
Data type: BYTE Applies with effect from SW version: 6.2
Meaning: Retain or deactivate work area limitation when switching geometrical axes.
The MD is bit--coded and has the following meaning:
Bit = =0: Deactivate work area limitation when switching geometrical axes
=1: Retain work area limitation when switching geometrical axes
This MD cannot SINUMERIK 802D sl.
10615 NCFRAME_POWERON_MASK
MD number Delete global base frames on Power On
Default setting: 0 Minimum input limit: 0 Maximum input limit: 0
Changes effective after Power On Protection level: 2/7 Unit: --
Data type: DWORD Applies with effect from SW version: 5.2
Meaning: This machine data defines whether global base frames are deleted on a Power On reset.
The selection can be made separately for the individual base frames.
Bit 0 corresponds to base frame 0, bit 1 to base frame 1, etc.
0: Base frame is retained on Power On
1: Base frame is deleted on Power On.
This MD cannot SINUMERIK 802D sl.
D

Siemens SINUMERIK 802D sl Specifications

General

Brand	Siemens
Model	SINUMERIK 802D sl
Category	Controller
Language	English