Siemens SINUMERIK 802D sl - D.2 Channel-Specific Machine Data

Machine and Setting Data
D.2 Channel-specific machine data
04.07
D-226
© Siemens AG 2007 All rights reserved
SINUMERIK 802D sl/840D/840D sl/840Di/840Di sl/810D ISO Milling (PGM) -- 04.07 Edition
18800 MM_EXTERN_LANGUAGE
MD number External language active in the control
Default setting: 0 Minimum input limit: 0 Maximum input limit: 1
Changes effective after Power On Protection level: 2/7 Unit: --
Datentype: DWORD Applies with effect from SW version: 5
Meaning: This MD must be set to enable ISO Dialect0--T and ISO Dialect0--M programs to run on the
control. Only one external language can be selected at a time. Please refer to the latest
documentation for the available command range.
Bit 0 (LSB): Execution of part programs in ISO_2 or ISO_3 mode. For coding see
$MN_MM_EXTERN_CNC_SYSTEM (10880)
This MD cannot SINUMERIK 802D sl.
D.2 Channel-specific machine data
20050 AXCONF_GEO AX_ASSIGN_TAB
MD number Assignment between geometry axis and channel axis
Default setting: 70 Minimum input limit: 0 Maximum input limit: 20
Changes effective after Power ON Protection level: 2/2 Unit: --
Data type: BYTE Applies with effect from SW version: 5.2
Meaning: This MD assigns a geometry axis to a channel axis.
The assignment must be made for all 3 geometry axes (X,Y,Z). If a geometry axis is not
assigned, the value 0 should be entered. The geometry axis is therefore not available and
cannot be programmed, e.g. if the second geometry axis is not required for the “turning”
technology Y --> entry: value 0 (see default setting for turning).
20060 AXCONF_GEOAX_NAME_TAB
MD number Geometry axis name in channel
Default setting: X, Y, Z Minimum input limit: -- Maximum input limit: --
Changes effective after Power ON Protection level: 2/7 Unit: --
Data type: STRING Applies with effect from SW version:
Meaning: This MD is used to enter the names of the geometry axes for the channel separately.
Geometry axes can be programmed in the part program using the names specified here.
20070 AXCONF_MACHAX_USED
MD number Machine axis number valid in channel
Default setting: 1, 2, 3, 4 Minimum input limit: 0 Maximum input limit: 31
Changes effective after Power ON Protection level: 2/7 Unit: --
Data type: BYTE Applies with effect from SW version:
Meaning: This MD assigns a machine axis to a channel axis.
SINUMERIK 802D has 5 channel axes. Channel axis identifiers for the axes activated in
the channel must be specified in MD 20080: AXCONF_CHANAX_NAME_TAB. The axes
can be programmed.
A machine axis that has not been assigned to a channel axis is not active i.e. no axis
control, no display on the screen.