Siemens SINUMERIK 802D sl Programming Manual

Machine and Setting Data
D.2 Channel-specific machine data
04.07
D-227
© Siemens AG 2007 All rights reserved
SINUMERIK 802D sl/840D/840D sl/840Di/840Di sl/810D ISO Milling (PGM) -- 04.07 Edition
20080 AXCONF_CHANAX_NAME_TAB
MD number Channel axis name
Default setting:
X, Y, Z, A, B, C, U, V, X11, Y11, ...
Minimum input limit: -- Maximum input limit: --
Changes effective after Power ON Protection level: 2/7 Unit: --
Data type: STRING Applies with effect from SW version:
Meaning: In this MD you can set the name of the channel axis.
The channel axis is displayed with this identifier in the WCS. This identifier is also written in
the program.
Generally , the first two or three channel axes are used as geometry axes (see also MD
20050: AXCONF_GEOAX_ASSIGN_TAB). The remaining channel axes are defined as
special axes. SINUMERIK 802D has 5 channel axes.
20094 SPIND_RIGID_TAPPING_M_NR
MD number M number for switchover to controlled spindle mode (Siemens mode)
Default setting: 70 Minimum input limit: 0 Maximum input limit: 0xFF
Changes effective after POWER ON Protection level: 2/7 Unit: --
Data type: BYTE Applies with effect from SW version: 5.2
Meaning:
The machine data is effective in Siemens mode and in external language mode.
This machine data defines the M function number used to switch the spindle to
controlled spindle mode (axis mode). This number is substituted by M70 in Sie-
mens mode and by M29 in external language mode. Only M numbers which
have not already been defined as defaults are allowed. M codes M1, M2, M3,
M4, M5, M30, etc. are not allowed, for example.
20095 EXTERN_RIGID_TAPPING_M_NR
MD number M number for switchover to controlled spindle mode (external language mode)
Default setting: 29 Minimum input limit: 6 Maximum input limit: 0xFF
Changes effective after POWER ON Protection level: 2/7 Unit: --
Data type: BYTE Applies with effect from SW version:
Meaning:
This machine data defines the M function number used to switch the spindle to
controlled spindle mode (axis mode) in external language mode. This number
can be used in external language mode to substitute M29 with another M func-
tion.
Only M numbers which have not already been defined as defaults are allowed.
M c odes M0, M1, M3, M4, M5, M30, M99 etc. are not allowed, for example.

Siemens SINUMERIK 802D sl Specifications

General

Brand	Siemens
Model	SINUMERIK 802D sl
Category	Controller
Language	English