To Next Page

To Previous Page

Enhanced Level Commands

4.1 Program support functions (1)

04.07

4-115

SINUMERIK 802D sl/840D/840D sl/840Di/840Di sl/810D ISO Milling (PGM) -- 04.07 Edition

Q/R

By all means, specify a positive value at address Q. The sign is ignored if address

Q is specified with a negative value. Q equal 0 is set whenever no lift--off amount is

programmed. This leads to cycle execution without lift--off.

Cancel

G codes of group 01 (G00 to G03) and G87 must not be specified in a single block.

Otherwise, G87 is canceled.

Tool offset

Tool offsets are ignored in the canned cycle mode.

Example

M3 S400; Rotate spindle

G90G0Z100

G90 G87 X200. Y --150. Z--100. R150. Q3. P1000 F150.;

Position, bore hole 1,

orient at the initial level, then shift by 3 mm,

stop at point Z for 1 s

Y--500.; Position, drill hole 2.

Y--700.; Position, drill hole 3.

X950.; Position, drill hole 4.

Y--500.; Position, drill hole 5.

Y--700.; Position, drill hole 6

G80; Cancel canned cycle

G28 G91 X0 Y0 Z0; Return to the reference position return

M5; Spindle stop

06.01

Siemens SINUMERIK 802D sl Programming Manual

Other manuals for Siemens SINUMERIK 802D sl