Siemens SINUMERIK 802D sl - Page 120

Enhanced Level Commands
4.1 Program support functions (1)
04.07
4-120
© Siemens AG 2007 All rights reserved
SINUMERIK 802D sl/840D/840D sl/840Di/840Di sl/810D ISO Milling (PGM) -- 04.07 Edition
Tool offset
Tool offsets are ignored in the canned cycle mode.
Example
Z axis feedrate 1000 mm/min
Spindle speed 1000 rpm
Thread lead 1.0 mm
<Programming of feed per minute>
S1000 M3;
G94; Feed--per--minute
G00 X100.0 Y100.0; Positioning
G84 Z--50.0 R--10.0 F1000; Rigid tapping
<Programming of feed per revolution>
G95; Feed--per--revolution
G00 X100.0 Y100.0; Positioning
G84 Z--50.0 R--10.0 F1.0; Rigid tapping