Enhanced Level Commands
4.7 Cylindrical interpolation (G07.1)
04.07
4-142
© Siemens AG 2007 All rights reserved
SINUMERIK 802D sl/840D/840D sl/840Di/840Di sl/810D ISO Milling (PGM) -- 04.07 Edition
Relationship between the Cylindrical Interpolation and Operations
S The following functions cannot be specified in the cylindrical interpolation mode.
Similarly, it is not allowed to specify the G07.1 command while any of the func-
tions indicated below is called.
-- Mirror image
-- Scaling (G50, G51)
-- Coordinate r otation ( G68)
-- Base coordinate system setting
S Overrides (rapid traverse, jog, spindle s peed) are valid.
S When the cylindrical interpolation mode is canceled, the interpolation plane se-
lected before the call of the cylindrical interpolation mode is recovered.
S In the cylindrical interpolation mode, the stored stroke limit function is valid.
S To execute tool length offset, specify the tool length offset c ommand before
specifying the G07.1 command.
S The workpiece coordinate (G54 - G59) must be specified before specifying the
G07.1 command.
To Next Page
Loading...
