To Next Page

To Previous Page

Enhanced Level Commands

4.11 Additional functions

04.07

4-167

SINUMERIK 802D sl/840D/840D sl/840Di/840Di sl/810D ISO Milling (PGM) -- 04.07 Edition

Note

The NCK processes blocks in two stages, the preprocessing and main runs. The

result of the preprocessing run is transferred to the preprocessing memory from

where the main run fetches the oldest block in each case and traverses its geome-

try.

Attention

When you set machine data $MN_SLASH_MASK==2, the preprocessing run is

switched over when the skip levels are changed! All blocks stored in the prepro-

cessing memory are traversed with the old skip level. As the user, you generally

have no control over the fill level of the preprocessing memory. From your viewpo-

int, therefore, the new skip level will become operative ”at some point” after the

levels are switched!

Note

Part program command STOPRE clears the preprocessing memory. If you switch

the skip level over before the STOPRE command, all blocks after the command

will be reliably changed over. The same applies to an implicit STOPRE.

Switching over DryRun mode is subject to analogous restrictions.

If you set machine data $MN_DRYRUN_MASK==2, no drop in velocity will be ne-

cessary when you change over the DryRun mode. In this instance as well, howe-

ver, it is only the preprocessing run that is switched over, resulting in the restric-

tions described above. In other words: Watch out! DryRun mode will become

active ”at some time” after it has been switched over!

Siemens SINUMERIK 802D sl Programming Manual

Other manuals for Siemens SINUMERIK 802D sl