Terms
04.07
B-194
© Siemens AG 2007 All rights reserved
SINUMERIK 802D sl/840D/840D sl/840Di/840Di sl/810D ISO Milling (PGM) -- 04.07 Edition
L
Languages The user interface texts, system messages and alarms are available
in five system languages (floppy disk):
German, English, French, Italian and Spanish.
The user can select two of the listed languages at a time in the
control.
Leadscrew error
compensation
Compensation of mechanical inaccuracies in a leadscrew involved
in the feed motion. Errors are compensated by the control based on
stored deviation measurements.
Limit speed Minimum/maximum (spindle) speed: The maximum speed of a
spindle can be limited by values defined in the machine data, the -->
PLC or --> setting data.
Linear axis The linear axis is an axis which, in contrast to a rotary axis,
describes a straight line.
Linear interpolation The tool travels along a straight line to the destination point while
machining the workpiece.
Look Ahead The Look Ahead function is a means of optimizing the machining
velocity by looking ahead over a parameterizable number of
traversing blocks.
Look Ahead for
contour violations
The control detects and reports the following types of collision:
1. Path is shorter than tool radius.
2. Width of inside corner is less than the tool diameter.
M
Machine Control operating area
Machine axes Axes which exist physically on the machine tool.
Machine control panel An operator panel on a machine tool with operating elements such
as keys, rotary switches, etc. and simple indicators such as LEDs. It
is used for direct control of the machine tool via the PLC.
To Next Page
Loading...
