Commands Calling Axis Movements
2.1 Interpolation commands
04.07
2-24
© Siemens AG 2007 All rights reserved
SINUMERIK 802D sl/840D/840D sl/840Di/840Di sl/810D ISO Milling (PGM) -- 04.07 Edition
Example of programming
Y-axis
40.
40.
X-axis
Z-axis
40.
G00 X40. Y40. Z40.;
Rapid traverse rate
X--axis: 8 mm/min
Y--axis: 8 mm/min
Z --axis: 4 mm/min
Fig. 2-1 Positioning in simultaneous 3-axis control mode
Note
In the G00 positioning mode, since the axes move at a rapid traverse rate set for
the individual axes independently, the tool paths are not always a straight line.
Therefore, positioning must be programmed carefully so that a c utting tool will not
interfere with a workpiece or fixture during positioning.
G0 Linear Mode
The G0 linear mode is valid if MD $MC_EXTERN_G0_LINEAR_MODE is set. In
this case, all programmed axes move in linear interpolation and reach their target
position at the same point of time.
To Next Page
Loading...
