Siemens SINUMERIK 802D sl Programming Manual

Data Fields, Lists
E.1 Machine data
04.07
E-240
© Siemens AG 2007 All rights reserved
SINUMERIK 802D sl/840D/840D sl/840Di/840Di sl/810D ISO Milling (PGM) -- 04.07 Edition
General ($MN_ ... )
10881 EXTERN_GCODE_SYSTEM ISO mode T: G code system selection
10882 NC_USER_EXTERN_GCODES_TAB[n]:
0--59
List of user defined G commands for external
NC language
10884 EXTERN_FLOATINGPOINT_PROG Evaluation for progr. without decimal point
10886 EXTERN_INCREMENT_SYSTEM Defines the increment system
10888 EXTERN_DIGITS_TOOL_NO Number of digits for T number in external lan--
guage mode
10890 EXTERN_TOOLPROG_MODE Tool change programming with external pro--
gramming language
18190 MM_NUM_PROTECT_AREA_NCK Number of files for machine related protection
zones (SRAM)
S7
18800 MM_EXTERN_LANGUAGE External language active in the control
Channel--specific ($MC_ ... )
20050 AXCONF_GEOAX_ASSIGN_TAB[ ] Assignment geometrical axis / channel axis K2
20060 AXCONF_GEOAX_NAME_TAB[ ] Geometrical axis in channel K2
20070 AXCONF_MACHAX_USED[ ] V alid machine axis number in channel K2
20080 AXCONF_CHANAX_NAME_TAB[ ] Channel axis designation in channel K2
20094 SPIND_RIGID_TAPPING_M_NR M function number with which the spindle swit-
ches to controlled spindle mode
20095 EXTERN_RIGID_TAPPING_M_NR M function number in external language mode
for spindle switchover to controlled spindle
mode
20100 DIAMETER_AX_DEF Geometrical axis with cross axis functionality P1
20150 GCODE_RESET_VALUES[n]: 0 bis max. An-
zahl G--Codes
G code groups reset values K1
20152 GCODE_RESET_MODE Reset response in the G group
20154 EXTERN_GCODE_RESET_VALUES[n]: 0--30 G code groups reset values
20380 T OOL_CORR_MODE_G43G44 Behaviour of tool length compensation
G43/G44
20382 TOOL_CORR_MOVE_MODE Traversing tool length compensation
20732 EXTERN_G0_LINEAR_MODE Determine traverse movement of G00
20734 EXTERN_FUNCTION_MASK External language function mask
22420 FGROUP_DEFAULT_AXES[ ] FGROUP command default value
22512 EXTERN_GCODE_GROUPS_TO_PLC[n]:
0--7
Specifies the G groups which are output to the
NCK/PLC interface when an external NC lan--
guage is active
22900 STROKE_CHECK_INSIDE Protection zone direction (inside/outside)
22910 WEIGHTING_FACTOR_FOR_SCALE Unit of scale factor
22914 AXES_SCALE_ENABLE Enable axial scaling (G51)
22920 EXTERN_FEEDRA TE_F1_F9_ACTIV Enable F 1--digit feed (F0 -- F9)
22930 EXTERN_PARALLEL_GEOAX Assign parallel channel geometry axis
24004 CHBFRAME_POWERON_MASK Delete channel--specific base frame on
Power On
24006 CHSFRAME_RESET_MASK Active system frames after reset

Siemens SINUMERIK 802D sl Specifications

General

Brand	Siemens
Model	SINUMERIK 802D sl
Category	Controller
Language	English