Siemens SINUMERIK 802D sl - Page 243

Data Fields, Lists
E.3 Variables
04.07
E-243
© Siemens AG 2007 All rights reserved
SINUMERIK 802D sl/840D/840D sl/840Di/840Di sl/810D ISO Milling (PGM) -- 04.07 Edition
Identifier DescriptionType
$C_I_NUM INT Cycle programming: Value is always 1 if bit 0 set in $C_I_PROG.
Macro programming: Number of I addresses programmed in block (max. 10).
$C_J_NUM INT For description see $C_I_NUM
$C_K_NUM INT For description see $C_I_NUM
$P_AP INT Polar coordinates 0 = OFF 1 = ON
$C_TYP_PROG INT Bit map of all programmed addresses in a block with a cycle call
Bit 0 = A
Bit 25 = Z
Bit = 0 axis programmed as INT
Bit = 1 axis programmed as REAL
$C_PI INT Program number of the interrupt routine that was programmed with M96