Siemens SINUMERIK 802D sl Programming Manual

Preface
04.07
iv
© Siemens AG 2007 All rights reserved
SINUMERIK 802D sl/840D/840D sl/840Di/840Di sl/810D ISO Milling (PGM) -- 04.07 Edition
Technical Support
If you have any questions, please get in touch with our Hotline:
Europe / Africa Asia / Australia America
Phone +49 180 5050 222 +86 1064 719 990 +1 423 262 2522
Fax +49 180 5050 223 +86 1064 747 474 +1 423 262 2289
Internet http:// www .siemens.com/automation/support--request
E-- Mail mailto:adsupport@siemens.com
Note
Should you require technical support, please call one of the country--specific
phone numbers provided on the Internet:
http://www
.siemens.com/automation/services&support
Questions regarding the manual
If you have any queries (suggestions, corrections) in relation to this documentation,
please send a fax or e--mail to the following address:
Fax +49 9131 98 63315
E-- Mail mailto:motioncontrol.docu@siemens.com
Fax form: see reply form at the end of the manual.
SINUMERIK Internet address
http://www.siemens.com/sinumerik
Origin
In contrast to the Siemens mode programming of YASKA WA SIEMENS 840DI,
ISO dialect programming is mainly based on SINUMERIK 6T--B and SINUMERIK
6M--B, a CNC control which had already been phased out. However, OEM and en-
duser requirements on SINUMERIK 6T--B programming compatibility lead to the
development of the ISO dialect function.

Siemens SINUMERIK 802D sl Specifications

General

Brand	Siemens
Model	SINUMERIK 802D sl
Category	Controller
Language	English