Preface
04.07
vi
© Siemens AG 2007 All rights reserved
SINUMERIK 802D sl/840D/840D sl/840Di/840Di sl/810D ISO Milling (PGM) -- 04.07 Edition
Qualified personnel
The associated device/system may only be set up and operated using this docu-
mentation. Commissioning and operation of a device/system may only be perfor-
med by qualified personnel. Qualified persons are defined as persons who are
authorized to commission, to ground, and to tag circuits, equipment, and systems
in accordance with established safety practices and standards.
Prescribed Usage
Please note the following:
!
Warning
The equipment may only be used for single purpose applications explicitly descri-
bed in the catalog and in the technical description and it may only be used along
with third--party devices and components recommended by Siemens. To ensure
trouble--free and safe operation of the product, it must be transported, stored and
installed as intended and maintained and operated with care.
Further notes
Note
This icon is displayed in the present documentation whenever additional facts are
being specified.
To Next Page
Loading...
Need help?
General
