Siemens SINUMERIK 828D Programming Manual

Path traversing behavior
8.2 Feedrate response (FNORM, FLIN, FCUB, FPO)
Job planning
460 Programming Manual, 07/2010, 6FC5398-2BP40-0BA0
FNORM
The feed address F defines the path feed as a constant value according to DIN 66025.
Please refer to Programming Manual "Fundamentals" for more detailed information on this
subject.
)HHG
3DWK
FLIN
The feed characteristic is approached linearly from the current feed value to the programmed
F value until the end of the block.
Example:
N30 F1400 FLIN X50
)HHG
3DWK

Siemens SINUMERIK 828D Specifications

General

Control Type	CNC
Operating System	Windows Embedded
Processor	Intel Atom
Display	10.4" color TFT display
Interfaces	Ethernet, USB
Programming	ShopMill, ShopTurn
Operation Panel Size	10.4"
Protection Class	IP65
PLC Memory	2 MB
Spindle Capacity	4 spindles
Hard Drive	CompactFlash