Siemens SINUMERIK 828D - Page 481

Path traversing behavior
8.6 Repositioning to a contour (REPOSA, REPOSL, REPOSQ, REPOSQA, REPOSH, REPOSHA, DISR,
DISPR, RMI, RMB, RME, RMN)
Job planning
Programming Manual, 07/2010, 6FC5398-2BP40-0BA0
481
SERUPRO approach with RMN
If abort is forced during machining at any position, the shortest path from the abort point is
approached with SERUPRO approach and
RMN so that afterward only the distance-to-go is
processed. The user starts a SERUPRO process at the interruption block and uses the JOG
keys to move in front of the problem component of the target block.
<
;
50, 50%
501
50(
6(58352DSSURDFK
$FWXDOSRVLWLRQIRUEORFNVHDUFK
%ORFNVWDUWSRLQW
3RVLWLRQUHDFKHGXVLQJ
-2*NH\
%ORFNHQGSRLQW
Note
SERUPRO
For
SERUPRO, RMI and RMB are identical. RMN is not limited to SERUPRO but is generally
applicable.