Tables
16.1 Instructions
Job planning
Programming Manual, 07/2010, 6FC5398-2BP40-0BA0
723
Operation Meaning W
1)
Description see
2)
DISPLOF Suppress current block display
PGAsl
Suppress current block display (DISPLOF, DISPLON,
ACTBLOCNO) (Page 168)
DISPLON Revoke suppression of the current block
display
PGAsl
Suppress current block display (DISPLOF, DISPLON,
ACTBLOCNO) (Page 168)
DISPR Path differential for repositioning s
PGAsl
Repositioning to a contour (REPOSA, REPOSL,
REPOSQ, REPOSQA, REPOSH, REPOSHA, DISR,
DISPR, RMI, RMB, RME, RMN) (Page 475)
DISR Distance for repositioning s
PGAsl
Repositioning to a contour (REPOSA, REPOSL,
REPOSQ, REPOSQA, REPOSH, REPOSHA, DISR,
DISPR, RMI, RMB, RME, RMN) (Page 475)
DITE Thread run-out path m
PGsl
DITS Thread run-in path m
PGsl
DIV Integer division
PGAsl
Arithmetic functions (Page 63)
DL Select location-dependent additive tool
offset (DL, total set-up offset)
m
PGAsl
Selecting additive offsets (DL) (Page 392)
DO Keyword for synchronized action,
triggers action when condition is fulfilled
PGAsl
Actions (DO) (Page 555)
DRFOF Deactivation of handwheel offsets (DRF) m
PGsl
DRIVE Velocity-dependent path acceleration m
PGsl
DRIVEA Activate bent acceleration characteristic
curve for the programmed axes
PGsl
DYNFINISH Dynamic response for smooth finishing m
PGsl
DYNNORM Standard dynamic response m
PGsl
DYNPOS Dynamic response for positioning mode,
tapping
m
PGsl
DYNROUGH Dynamic response for roughing m
PGsl
DYNSEMIFIN Dynamic response for finishing m
PGsl
DZERO Marks all D numbers of the TO unit as
invalid
PGAsl
Free assignment of D numbers: Invalidate D numbers
(DZERO) (Page
433)
To Next Page
Loading...
