Tables
16.1 Instructions
Job planning
Programming Manual, 07/2010, 6FC5398-2BP40-0BA0
735
Operation Meaning W
1)
Description see
2)
IPTRUNLOCK Set end of untraceable program section
at current block at time of interruption
m
PGAsl
Preventing program position for SERUPRO
(IPTRLOCK, IPTRUNLOCK) (Page 472)
ISAXIS Check if geometry axis 1 specified as
parameter
PGAsl
Axis functions (AXNAME, AX, SPI, AXTOSPI, ISAXIS,
AXSTRING, MODAXVAL) (Page 661)
ISD Insertion depth m
PGAsl
Activating 3D tool offsets (CUT3DC, CUT3DF,
CUT3DFS, CUT3DFF, ISD) (Page 409)
ISFILE Check whether the file exists in the
NCK application memory
PGAsl
Check for presence of file (ISFILE) (Page 141)
ISNUMBER Check whether the input string can be
converted to a number
PGAsl
Type conversion from STRING (NUMBER, ISNUMBER,
AXNAME) (Page
76)
ISOCALL Indirect call of a program programmed
in an ISO language
PGAsl
Indirect call of a program programmed in ISO language
(ISOCALL) (Page 192)
ISVAR Check whether the transfer parameter
contains a variable declared in the NC
PGAsl
Function call ISVAR and read machine data array index
(Page 678)
J Interpolation parameters s
PGsl
J1 Intermediate point coordinate s
PGsl
JERKA Activate acceleration response set via
MD for programmed axes
JERKLIM Reduction or overshoot of maximum
axial jerk
m
PGAsl
Percentage jerk correction (JERKLIM) (Page 485)
JERKLIMA Reduction or overshoot of maximum
axial jerk
m
PGsl
K Interpolation parameters s
PGsl
K1 Intermediate point coordinate s
PGsl
KONT Travel around contour on tool offset m
PGsl
KONTC Approach/retract with continuous-
curvature polynomial
m
PGsl
KONTT Approach/retract with continuous-
tangent polynomial
m
PGsl
L Subprogram number s
PGAsl
Subprogram call without parameter transfer (Page 181)
LEAD Lead angle
1. Tool orientation
2. Orientation polynomial
m
PGAsl
Programming of the tool orientation (A..., B..., C...,
LEAD, TILT) (Page 323)
To Next Page
Loading...
