Siemens SINUMERIK 828D

Tables
16.1 Instructions
Job planning
736 Programming Manual, 07/2010, 6FC5398-2BP40-0BA0
Operation Meaning W
1)
Description see
2)
LEADOF Master value coupling OFF PGAsl
Axial leading value coupling (LEADON, LEADOF)
(Page 520)
LEADON Master value coupling ON PGAsl
Axial leading value coupling (LEADON, LEADOF)
(Page 520)
LENTOAX Provides information about the
assignment of tool lengths L1, L2, and
L3 of the active tool to the abscissa,
ordinate and applicate
FB1(W1)
LFOF
3)
Fast retraction for thread cutting OFF m PGsl
LFON Fast retraction for thread cutting ON m PGsl
LFPOS Retraction of the axis declared with
POLFMASK or POLFMLIN to the
absolute axis position programmed with
POLF
m PGsl
LFTXT The plane of the retraction movement
for fast retraction is determined from
the path tangent and the current tool
direction
m PGsl
LFWP The plane of the retraction movement
for fast retraction is determined by the
current working plane (G17/G18/G19)
m PGsl
LIFTFAST Fast retraction PGsl
Fast retraction from the contour (SETINT LIFTFAST,
ALF) (Page 118)
LIMS Speed limitation
for G96/G961 and G97
m PGsl
LLI Lower limit value of variables PGAsl
Attribute: Limit values (LLI, ULI) (Page 36)
LN Natural logarithm PGAsl
Arithmetic functions (Page 63)
LOCK Disable synchronized action with ID
(stop technology cycle)
PGAsl
Lock, unlock, reset (LOCK, UNLOCK, RESET)
(Page 627)
LONGHOLE Milling pattern cycle of elongated holes
on a circle
BHDsl/BHFsl
LOOP Introduction of an endless loop PGAsl
Continuous program loop (LOOP, ENDLOOP)
(Page 101)
M0 Programmed stop PGsl
M1 Optional stop PGsl