Tables
16.1 Instructions
Job planning
Programming Manual, 07/2010, 6FC5398-2BP40-0BA0
743
Operation Meaning W
1)
Description see
2)
OST Smoothing of tool orientation by
specifying angular tolerance in degrees
with SD (maximum deviation from
programmed orientation characteristic)
m
PGAsl
Tool orientation (ORIC, ORID, OSOF, OSC, OSS,
OSSE, ORIS, OSD, OST) (Page 423)
OST1 Oscillating: Stopping point in left
reversal point
m
PGAsl
Asynchronous oscillation (OS, OSP1, OSP2, OST1,
OST2, OSCTRL, OSNSC, OSE, OSB) (Page 633)
OST2 Oscillating: Stopping point in right
reversal point
m
PGAsl
Asynchronous oscillation (OS, OSP1, OSP2, OST1,
OST2, OSCTRL, OSNSC, OSE, OSB) (Page 633)
OTOL Orientation tolerance for compressor
functions, orientation smoothing and
smoothing types
PGAsl
Programmable contour/orientation tolerance (CTOL,
OTOL, ATOL) (Page 490)
OVR Speed offset m
PGAsl
OVRA Axial speed offset m
PGAsl
OVRRAP Rapid traverse override m
PGAsl
P Number of subprogram cycles
PGAsl
Number of program repetitions (P) (Page 186)
PAROT Align workpiece coordinate system on
workpiece
m
PGsl
PAROTOF Deactivate frame rotation in relation to
workpiece
m
PGsl
PCALL Call subprograms with absolute path
and parameter transfer
PGAsl
Calling subroutine with path specification and
parameters (PCALL) (Page
193)
PDELAYOF Punching with delay OFF m
PGAsl
Punching and nibbling on or off (SPOF, SON, PON,
SONS, PONS, PDELAYON, PDELAYOF, PUNCHACC)
(Page
647)
PDELAYON
3)
Punching with delay ON m
PGAsl
Punching and nibbling on or off (SPOF, SON, PON,
SONS, PONS, PDELAYON, PDELAYOF, PUNCHACC)
(Page
647)
PHU Physical unit of a variable
PGAsl
Definition of user variables (DEF) (Page 23)
PL 1. B spline: Node clearance
2. Polynomial interpolation: Length of
the parameter interval for polynomial
interpolation
s
PGAsl
1.
Spline interpolation (ASPLINE, BSPLINE, CSPLINE,
BAUTO, BNAT, BTAN, EAUTO, ENAT, ETAN, PW, SD,
PL) (Page 234)
2.
Polynomial interpolation (POLY, POLYPATH, PO,
PL) (Page
251)
PM Per minute
PGsl
To Next Page
Loading...
