R
RP R Parameter, arithmetic parameter, predefined user variable
RPA R Parameter Active: Memory area in the NC for R parameter numbers
RPY Roll Pitch Yaw: Rotation type of a coordinate system
RTLI Rapid Traverse Linear Interpolation: Linear interpolation during rapid traverse motion
RTS Request To Send: Control signal of serial data interfaces
RTCP Real Time Control Protocol
S
SA Synchronized Action
SBC Safe Brake Control: Safe Brake Control
SBL Single Block: Single block
SBR Subroutine: Subprogram (PLC)
SD Setting Data
SDB System Data Block
SEA Setting Data Active: Identifier (file type) for setting data
SERUPRO SEarch RUn by PROgram test: Block search, program test
SFB System Function Block
SFC System Function Call
SH Safe standstill
SIM Single in Line Module
SK Softkey
SKP Skip: Function for skipping a part program block
SLM Synchronous Linear Motor
SM Stepper Motor
SMC Sensor Module Cabinet Mounted
SME Sensor Module Externally Mounted
SMI Sensor Module Integrated
SPF Sub Routine File: Subprogram (NC)
PLC Programmable Logic Controller
SRAM Static RAM (non-volatile)
TNRC Tool Nose Radius Compensation
SRM Synchronous Rotary Motor
LEC Leadscrew Error Compensation
SSI Serial Synchronous Interface: Synchronous serial interface
SSL Block search
STW Control word
GWPS Grinding Wheel Peripheral Speed
SW Software
SYF System Files: System files
SYNACT SYNchronized ACTion: Synchronized Action
Appendix
A.1 List of abbreviations
NC programming
Programming Manual, 12/2019, 6FC5398-2EP40-0BA0 1311
To Next Page
Loading...
Need help?
General
