Measuring cycles are available in the following areas and technologies:
● Tool measurements, turning/milling
● Workpiece measurements, turning/milling
Further information
Measuring Cycles Programming Manual
3.25.3 Overview of measuring cycle parameters
3.25.3.1 CYCLE973 measuring cycle parameters
PROC CYCLE973(INT S_MVAR,INT S_PRNUM,INT S_CALNUM,REAL S_SETV,INT S_MA,INT S_MD,REAL
S_FA,REAL S_TSA,REAL S_VMS,INT S_NMSP,INT S_MCBIT,INT _DMODE,INT _AMODE)
Work preparation
3.25 Programming cycles externally
NC programming
Programming Manual, 12/2019, 6FC5398-2EP40-0BA0 1155
To Next Page
Loading...
Need help?
General
