No. Screen
form param‐
eter
Cycle pa‐
rameter
Meaning
13 DL S_DLNUM Setup additive offset DL number
5)
14 ST _DP Number of the replacement tool (duplo number) to be corrected
15 TZL S_TZL Work offset
2), 4)
16 DIF S_TDIF Dimensional difference check
2), 4)
17 TUL S_TUL Upper tolerance limit (incremental to the setpoint)
4)
18 TLL S_TLL Lower tolerance limit (incremental to the setpoint)
4)
19 TMV S_TMV Offset range for averaging
2)
20 FW S_K Weighting factor for averaging
2)
21 EVN S_EVNUM Number of the empirical value memory
2), 7)
22 S_MCBIT Reserved
23 _DMODE Display mode
Val‐
ues:
UNITS: Machining plane G17/G18/G19
0 = Compatibility, the plane active before the cycle call remains active
1 = G17 (only active in the cycle)
2 = G18 (only active in the cycle)
3 = G19 (only active in the cycle)
24 _AMODE Alternative mode
Val‐
ues:
UNITS: Dimensional tolerance yes/no
0 = No
1 = Yes
1)
All default values = 0 or marked as default=x
2)
Display depends on the general SD54760 $SNS_MEA_FUNCTION_MASK_PIECE
3)
Correction in WO only possible for measurement without reversal
4)
For tool offset, observe the channel MD 20360 TOOL_PARAMETER_DEF_MASK
5)
Only if the "Setup additive offset" function has been set-up in the general MD 18108 $MN_MM_NUM_SUMCORR . In
addition, the general MD 18080 $MN_MM_TOOL_MANAGEMENT_MASK , bit8 must be set to 1.
6)
If WO "fine" has not been set up in MDs, correction is according to WO "coarse"
7)
Empirical averaging only possible for tool offset
Value range for empirical mean value memory:
1 to 20 numbers (n) of the empirical value memory, see channel-specific SD55623 $SCS_MEA_EMPIRIC_VALUE[n-1]
10000 to 200000 numbers (n) of the mean value memory, see channel-specific SD55625
$SCS_MEA_AVERAGE_VALUE[n-1]
8)
If Y axis is available on the machine
3.25.3.4 CYCLE976 measuring cycle parameters
PROC CYCLE976(INT S_MVAR,INT S_PRNUM,REAL S_SETV,REAL S_SETV0,INT S_MA,INT S_MD,REAL
S_FA,REAL S_TSA,REAL S_VMS,REAL S_STA1,INT S_NMSP,INT S_SETV1,INT _DMODE,INT _AMODE)
Work preparation
3.25 Programming cycles externally
NC programming
Programming Manual, 12/2019, 6FC5398-2EP40-0BA0 1163
To Next Page
Loading...
Need help?
General
