ANG=…
X… Z… ANG=…
● Rounding as transition between the straight lines:
ANG=… RND=...
X… Z… ANG=…
● Chamfer as transition between the straight lines:
ANG=… CHR=...
X… Z… ANG=…
Programming of the end point of the first straight line by specifying the coordinates
● Corner as transition between the straight lines:
X… Z…
X… Z…
● Rounding as transition between the straight lines:
X… Z… RND=...
X… Z…
● Chamfer as transition between the straight lines:
X… Z… CHR=...
X… Z…
Fundamentals
2.9 Motion commands
NC programming
Programming Manual, 12/2019, 6FC5398-2EP40-0BA0 215
To Next Page
Loading...
Need help?
General
