Table 3-1 Programmable setting data
Number Identifier G command
1)
42000 $SC_THREAD_START_ANGLE SF
42010 $SC_THREAD_RAMP_DISP DITS/DITE
42400 $SA_PUNCH_DWELLTIME PDELAYON
42800 $SA_SPIND_ASSIGN_TAB SETMS
43210 $SA_SPIND_MIN_VELO_G25 G25
43220 $SA_SPIND_MAX_VELO_G26 G26
43230 $SA_SPIND_MAX_VELO_LIMS LIMS
43300 $SA_ASSIGN_FEED_PER_REV_SOURCE FPRAON
43420 $SA_WORKAREA_LIMIT_PLUS G26
43430 $SA_WORKAREA_LIMIT_MINUS G25
43510 $SA_FIXED_STOP_TORQUE FXST
43520 $SA_FIXED_STOP_WINDOW FXSW
43700 $SA_OSCILL_REVERSE_POS1 OSP1
43710 $SA_OSCILL_REVERSE_POS2 OSP2
43720 $SA_OSCILL_DWELL_TIME1 OST1
43730 $SA_OSCILL_DWELL_TIME2 OST2
43740 $SA_OSCILL_VELO FA
43750 $SA_OSCILL_NUM_SPARK_CYCLES OSNSC
43760 $SA_OSCILL_END_POS OSE
43770 $SA_OSCILL_CTRL_MASK OSCTRL
43780 $SA_OSCILL_IS_ACTIVE OS
43790 $SA_OSCILL_START_POS OSB
1) This G command addresses the setting data.
Supplementary conditions
Initialization value: Global user variables (GUD)
● Only INIPO (Power On) can be defined as the initialization time for global user variables
(GUD) with the NC range of validity.
● In addition to INIPO (Power On), INIRE (reset) or INICF (NEWCONF) can be defined as
the initialization time for global user variables (GUD) with the CHAN range of validity.
● In the case of global user variables (GUD) with the CHAN range of validity and INIRE (reset)
or INICF (NEWCONF) initialization time, for an NC reset, mode group reset and "Activate
machine data", the variables are only reinitialized in the channels in which the named events
were triggered.
Initialization value: FRAME data type
It is not permitted to specify an initialization value for variables of the FRAME data type.
Variables of the FRAME data type are initialized implicitly and always with the default frame.
Work preparation
3.1 Flexible NC programming
NC programming
Programming Manual, 12/2019, 6FC5398-2EP40-0BA0 407
To Next Page
Loading...
Need help?
General
