EasyManuals Logo
Home>Siemens>Control Systems>SINUMERIK ONE MCP 2400.4c

Siemens SINUMERIK ONE MCP 2400.4c Programming Manual

Siemens SINUMERIK ONE MCP 2400.4c
1334 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #650 background imageLoading...
Page #650 background image
$P_TOOLFRAME TOROT and TOFRAME
$P_WPFRAME Workpiece reference points
$P_TRAFRAME Transformations
$P_PFRAME Current programmable frame
Current system frame For:
$P_CYCFRAME Cycles
P_ACTFRAME Current total frame
FRAME chaining Current frame is made up of the com‐
plete basic frame
$P_NCBFRAME [n] current global basic frames
System variable $P_NCBFRAME[n] can be used to read and write the current global basic
frame field elements. The resulting total basic frame is calculated by means of the write process
in the channel.
The modified frame is activated only in the channel in which the frame was programmed. If the
frame is to be modified for all channels of a control, $P_NCBFR[n] and $P_NCBFRAME[n] must
be written simultaneously. The other channels must then activate the frame, e.g. with G54.
Whenever a basic frame is written, the complete basic frame is calculated again.
$P_CHBFRAME[n] Current channel basic frames
System variable $P_CHBFRAME[n] can be used to read and write the current channel basic
frame field elements. The resulting complete basic frame is calculated by means of the write
process in the channel. Whenever a basic frame is written, the complete basic frame is
calculated again.
$P_BFRAME current 1st Basic frame in the channel
The predefined frame variable $P_BFRAME can be used to read and write the current basic
frame with the array index 0, which is valid in the channel, in the part program. The written basic
frame is immediately included in the calculation.
$P_BFRAME is identical to $P_CHBFRAME[0]. The system variable always has a valid default
value. If there is no channel-specific basic frame, an alarm is issued at read/write: "Frame:
statement not permissible".
$P_ACTBFRAME Complete basic frame
The $P_ACTFRAME variable determines the chained complete basic frame. The variable is
read-only.
$P_ACTFRAME corresponds to:
$P_NCBFRAME[0] : ... : $P_NCBFRAME[n] : $P_CHBFRAME[0] : ... : $P_CHBFRAME[n].
Work preparation
3.8 Coordinate transformations (frames)
NC programming
650 Programming Manual, 12/2019, 6FC5398-2EP40-0BA0

Table of Contents

Other manuals for Siemens SINUMERIK ONE MCP 2400.4c

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SINUMERIK ONE MCP 2400.4c and is the answer not in the manual?

Siemens SINUMERIK ONE MCP 2400.4c Specifications

General IconGeneral
BrandSiemens
ModelSINUMERIK ONE MCP 2400.4c
CategoryControl Systems
LanguageEnglish

Related product manuals