EasyManuals Logo

Siemens SINUMERIK ONE MCP 2400.4c Programming Manual

Siemens SINUMERIK ONE MCP 2400.4c
1334 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #932 background imageLoading...
Page #932 background image
Examples
Wait for synchronism condition FINE to be fulfilled for following spindle S2 and COARSE to
be fulfilled for following spindle S4: WAITC(S2,"FINE",S4,"COARSE")
Wait for synchronism condition according to COUPDEF to be fulfilled: WAITC( )
Deactivate coupling COUPOF
COUPOF can be used to define the turn-off behavior of the coupling:
Deactivation of coupling with immediate block change:
COUPOF(S2,S1) (with specification of leading spindle)
COUPOF(S2) (without specification of leading spindle)
Deactivation of coupling after switch-off positions have been crossed. The block change
takes place after the switch-off positions have been crossed.
COUPOF(S2,S1,150) (switch-off position FS: 150°)
COUPOF(S2,S1,150,30) (switch-off position FS: 150°, LS: 30°)
Deactivate coupling with following spindle stop COUPOFS
COUPOFS can be used to define the turn-off behavior of the coupling with following spindle stop:
Deactivation of coupling with following spindle stop and immediate block change:
COUPOFS(S2,S1) (with specification of leading spindle)
COUPOFS(S2) (without specification of leading spindle)
Deactivation of coupling after switch-off positions have been crossed with following spindle
stop. The block change takes place after the switch-off positions have been crossed.
COUPOFS(S2,S1,150) (switch-off position FS: 150°)
Delete couplings COUPDEL
COUPDEL deletes the coupling:
COUPDEL(S2,S1) (with specification of leading spindle)
COUPDEL(S2) (without specification of leading spindle)
Reset coupling parameters, COUPRES
COUPRES activates the coupling values parameterized in the machine and setting data:
COUPRES(S2,S1) (with specification of leading spindle)
COUPRES(S2) (without specification of leading spindle)
System variables
Current coupling status of following spindle
The current coupling status of a following spindle can be read bit-coded via:
<Value> = $AA_COUP_ACT[<FS>]
Work preparation
3.16 Axis couplings
NC programming
932 Programming Manual, 12/2019, 6FC5398-2EP40-0BA0

Table of Contents

Other manuals for Siemens SINUMERIK ONE MCP 2400.4c

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SINUMERIK ONE MCP 2400.4c and is the answer not in the manual?

Siemens SINUMERIK ONE MCP 2400.4c Specifications

General IconGeneral
BrandSiemens
ModelSINUMERIK ONE MCP 2400.4c
CategoryControl Systems
LanguageEnglish

Related product manuals