Siemens SINUMERIK

Programming and Operating Manual (Turning)
242 01/2017
13.6
Program simulation and execution
1.
Switch to "AUTO" mode.
2.
Press this softkey to open the program simulation window, and the program control mode
PRT is automatically activated.
3.
Press this key to start the simulation for the the selected part program.
4.
After you finish the simulation, you can press this s
oftkey to return to the program editor
window.
5
.
Press this softkey and the system automatically changes to "AUTO" mode in the machining
operating area.
6.
Make sure the following preconditions are met before start machining:
•
These two softkeys have been deactivated.
•
The feedrate override is 0%.
•
The safety door is closed and the coolant is switched on.
7.
Press this key to start workpiece machining.