Programming and Operating Manual (Turning)
250 01/2017
Views the service information
Defines the maintenance planner
Alarm operating area
Softkey functions
Press this key on the PPU to enter the alarm operating
area. You can check the NC and drive alarms using the
softkeys. PLC alarms are not sorted.
Displays all alarms sorted by their priorities. The highest priority alarm is at the beginning of the list.
Displays the alarms sorted by the time of their occurrence. The most recent alarm stands at the beginning of the list.
orted by the time of their occurrence. The oldest alarm stands at the beginning of the list.
Displays the alarms on the drives. Note that this softkey is available on the PPU161.3 and PPU160.2 only.
Stops/starts updating of pending alarms
nd manages the alarm log
Configures the access right for the remote control through the Ethernet connection. For more information about the
softkey function, see the SINUMERIK 808D/SINUMERIK 808D ADVANCED Commissioning Manual.
To Next Page
Loading...
