Siemens SINUMERIK

Programming and Operating Manual (Turning)
254 01/2017
A.2.2.1
Running the spindle manually
Note
Before running the spindle manually, make sure you have activated the tool.
Operating sequence
1.
Select the machining operating area.
2.
Switch to "JOG" mode.
3.
Press this key on the MCP to rotate the spindle counter
-clockwisely.
4.
Press this key on the MCP to stop the spindle rotation.
5.
Press this key on the MCP to rotate th
e spindle clockwisely.
10.
Use this softkey to return to the screen of the machining operating ar
ea.