Siemens SINUMERIK User Manual

Programming and Operating Manual (Turning)
300 01/2017
Address
Significance
Value assign-
ments
Information
Programming
TRACYL
Milling of the peripheral
surface
Kinematic transformation (avail-
able only if configured according-
ly)
TRACYL(20.4) ; separate
block; cylinder diameter:
20.4 mm
TRACYL(20.4,1) ; also
possible
TRANSMIT Milling of the face end Kinematic transformation (avail-
able only if configured according-
ly)
TRANSMIT ; separate
block
TRANSMIT(1) ; also pos-
sible
TRAFOOF Disable TRANSMIT,
TRACYL
Disables all the kinematic trans-
formations
TRAFOOF ; separate
block
Programming and Operating Manual (Turning)
01/2017
Trademarks
All names identified by ® are registered trademarks of
Siemens AG. The remaining trademarks in this publ
ication may be trademarks whose
use by third parties for their own purposes could violate the rights of the owner.
Disclaimer of Liability
We have reviewed the contents of this publication to ensure consistency with the hardware and software described. Sin
ce variance cannot
be precluded entirely, we cannot guarantee full consistency. However, the information in this publication is reviewed regular
ly and any
necessary corrections are included in subsequent editions.
Siemens AG
Division Digital Factory
Postfach 48 48
90026 NÜRNBERG
GERMANY

Siemens SINUMERIK Specifications

General

Interface	Ethernet, PROFIBUS, PROFINET, USB
Programming Languages	DIN/ISO
Display	TFT color display
Compatibility	Siemens drives and motors
Software	SINUMERIK Operate
Control Unit Type	CNC (Computer Numerical Control)
Safety Functions	Integrated safety functions up to SIL 3/PLe