Siemens SINUMERIK User Manual

Programming and Operating Manual (Turning)
62 01/2017
Note:
make sure this vertical softkey is not selected.
6.
Configure the network as required in the following window:
You can configure the DHCP with this key.
Note:
if you select "No" for DHCP, you must enter the IP address (which must belong to the
same
network as that of your computer) and subnet mask manually.
7.
Press this softkey to save the configuration. If you select "Yes" for DHCP, you also need to
restart the control system to activate the network configuration.
Creating and connecting a network drive
Proceed as follows to create and connect a network drive:
1.
Share a directory on your local disk on your computer.
2.
Select the program management operating area.
3.
Press this softkey to go to the network drive directory.
4.
Press this softkey to go to the window for configuring the network drives.
5.
Press this key to select a drive identifier: N1, N2, or N3.

Siemens SINUMERIK Specifications

General

Interface	Ethernet, PROFIBUS, PROFINET, USB
Programming Languages	DIN/ISO
Display	TFT color display
Compatibility	Siemens drives and motors
Software	SINUMERIK Operate
Control Unit Type	CNC (Computer Numerical Control)
Safety Functions	Integrated safety functions up to SIL 3/PLe