Siemens SITRANS P DS III - PROFIsafe Configuration and Commissioning

Functional safety
8.7 PROFIsafe
SITRANS P DS III with PROFIBUS PA
138 Operating Instructions, 06/2013, A5E00053276-07
8.7.4
Preconditions
CPU
The CPU must be capable of operating in fail-safe mode to be able to communicate with
PROFIsafe devices.
These F-CPUs are contained in the catalog ST 70, SIMATIC S7.
Electronic Device Description (EDD):
Operate your application in conjunction with the EDD and GSD of SITRANS P, series DSIII
PA PROFIsafe in the following system environment:
● with EDD version 01.02.01-53 with GSD "SI0180A6.GSD revision 1.03"
– PCS 7 V7.0 and F systems V5.2SP4 with library Failsafe Blocks (V1_2) or
– PCS 7 V7.0 and F systems V6.0 with library Failsafe Blocks (V1_2) or
● EDD version 01.02.02 or higher with GSD "SI0180A6.GSD revision 1.04" with
PCS 7 V7.0 SP1 and F systems V6.0 with library S7 F Systems Lib V1_3
● EDD version 01.02.03 or higher with GSD "SIEM8170.GSD revision 1.0" with
PCS7 V7.1 SP3 and F systems V6.1 with libraryS7 F Systems Lib V1_4
Note
With this EDD, the "PROFIBUS Ident number" parameter can be set to manufacturer
-
specific (3.01), PROFIsafe V1/V2
PROFIsafe device
For safety reasons, the PROFIsafe device ships with default settings. This means
PROFIsafe is deactivated. You activate PROFIsafe with the PROFIsafe commissioning.
Technical requirements for PROFIsafe:
● SIMATIC PDM HF1
● EDD from 01.02.01
● Firmware from 301.02.01
8.7.5
PROFIsafe Configuration
For safety reasons, the PROFIsafe device ships with default settings.
Requirement
Before you commission the PROFIsafe device, configure it, for example in STEP 7.