Siemens SITRANS P DS III - Local Operation Procedures

Operation
6.5 Local operation
SITRANS P DS III with PROFIBUS PA
76 Operating Instructions, 06/2013, A5E00053276-07
6.4.5
Status display
Description
The arrows of the status display have a different meaning depending on the mode setting.
The table below shows the meanings of the arrows in the respective functions.
Meaning
Table 6- 3 Meaning of the arrow displays
Function
Mode
Display
Display
Measured value display Pressure exceeds the upper
sensor limit.
Pressure falls below the lower
sensor limit.
Adjusting damping 4 Exceeds the upper damping
value
Falls below the lower damping
value
LO calibration
19
–
Calibration span too low
HI calibration
20
Calibration span too high
–
Alarm
Upper alarm limit reached
Lower alarm limit reached
Warning
Upper warning limit reached
Lower warning limit reached
See also
Overview of status codes (Page 185)
6.5
Local operation
6.5.1
Control elements for local operation
Introduction
You operate the transmitter on site using the buttons. You can select and execute the
functions described in the table using adjustable modes. Operation by buttons is not
available for devices without display.