Siemens SITRANS P DS III - Unit

Operation
6.5 Local operation
SITRANS P DS III with PROFIBUS PA
84 Operating Instructions, 06/2013, A5E00053276-07
Table 6- 7 Measurement type "Level (height)"
Source of measured value display
Variable
Available units
From analog input function block:
[0] : Output OUT (L)
(U)
Level
User specific
From pressure transducer block:
[1] : Secondary variable 1
SEC 1
(P)
Pressure
[2] : Measurement value (primary
variable)
PRIM (L) Level
[3] : Sensor temperature
TMP S
(T)
Temperature
[4] : Electronics temperature
TMP E
(T)
Temperature
Table 6- 8 Measurement type "Level (volume)"
Source of measured value display
Variable
Available units
From analog input function block:
[0] : Output OUT (V)
(U)
Volume
User specific
From pressure transducer block:
[1] : Secondary variable 1
SEC 1
(P)
Pressure
[2] : Measurement value (primary
variable)
PRIM (V) Volume
[3] : Sensor temperature TMP S (T) Temperature
[4] : Electronics temperature
TMP E
(T)
Temperature
See also
Block model for collection and processing of measured values (Page 95)
Pressure transducer block (transducer block 1) (Page 98)
6.5.7
Unit
Introduction
In mode 14, set the physical unit in which the device's measured value display should be
represented.
Requirement
You have already selected the desired source for the measured value display in mode 13.