Installing / mounting
4.7 Rotating the display
SITRANS P DS III with PROFIBUS PA
62 Operating Instructions, 06/2013, A5E00053276-07
You can rotate the display in the electronics enclosure. This makes it easier to read the
display if the device is not being operated in a vertical position.
1. Unscrew the cover of the electrical cable compartment. See section Structure (Page 24).
An identification text "FIELD TERMINAL" is provided at the side of the housing.
2. Unscrew the display. Depending on the application position of the transmitter, you can
reinstall it at four different positions. You can turn it by ±90° or ±180°.
3. Screw the covers back on as far as they will go.
4. Secure the covers with the cover catch.
To Next Page
Loading...
