Siemens SITRANS P DS III - Configuration with Host System

Functional safety
8.7 PROFIsafe
SITRANS P DS III with PROFIBUS PA
156 Operating Instructions, 06/2013, A5E00053276-07
Device modes
Display
Meaning
[0]:
Profile-compliant:
Can be replaced by transducers complying with PROFIBUS PA profile 3.0 with analog
input function block (without totalizer) (only as standard device)
[1]:
State as shipped
Profile-compliant with expansions:
Full range of functions of the SITRANS P, series DS III PROFIsafe with:
• Analog input function block
• Safe analog input
• Totalizer
PROFIsafe communication in mode V1 or V2 possible
[2]:
Can be replaced by the predecessor device SITRANS P, series DS III PA (only as
standard device)
[128]:
Profile-compliant:
Can be replaced by transducers complying with PROFIBUS PA profile 3.0 with analog
input function block (without totalizer) (only as standard device)
• Analog input function block
• Totalizer
[129]:
• Can be replaced by SITRANS P, series DS III PROFIsafe with PROFIsafe
communication only possible in V1 mode.
• In this device mode, a SITRANS P, series DS III PA (standard device with Profibus
profile 3.00 or 3.01) can be replaced by a SITRANS P, series DS III PROFIsafe (as of
firmware version 0301.02.03).
A specific Generic Station Description (GSD) file is assigned to each device mode:
Display
File name
[0]:
pa_29700.gsd or pa_39700.gsd
[1]:
siem8170.gsd
[2]:
sip1804B.gsd
[128]:
pa_29740.gsd or pa_39740.gsd
[129]:
SI0180A6.gsd or SIEM80A6.gsd or SI0280A6.gsd
8.7.9.2
Configuration with host system
Note
Generic Station Description (GSD)
The generic station description file in HW Config remains the same: SI0180A6.gsd
.